
A 190 mm impeller diameter and a 95 W input power listing are enough to shortlist the AFL Motor B3P190-EC072-061 for review. To approve it for a compact air-handling unit (AHU), the equipment engineer still needs to verify two things: the airflow it delivers against the unit’s resistance, and the space the assembled fan needs inside the cabinet.

What does the AFL model sheet establish?
AFL lists the B3P190-EC072-061 as an EC backward-curved centrifugal fan with a 220 VAC, 50/60 Hz supply, a listed speed of 3,600 rpm and input power of 95 W. The 190 mm figure describes the impeller diameter. It gives purchasing a size class to search for, while the outline drawing gives the engineer the dimensions needed to check fit. Keep the full model code on the drawing request so the supplier can identify the exact variant.
Will it deliver the required airflow once the filter is installed?
Give the supplier a pair of values for each operating condition: airflow in m³/h and the corresponding required fan static pressure in Pa. For example, if the unit must maintain the same airflow as the filter loads, send the clean-filter and loaded-filter requirements separately. Ask the supplier to mark both points on the curve for this model and identify the speed and input power at each. Treat the catalogue’s 95 W as a listed specification until the supplier confirms power at your points.
What could prevent a 190 mm fan from fitting?
Send a section drawing through the proposed inlet and mounting plane. Ask the supplier to overlay the fan outline and mark the mounting holes, depth behind the plate, inlet clearance and cable exit. A cabinet can accommodate the impeller diameter yet leave too little space to route the cable or remove the assembly for service. Before ordering a sample, have the engineer who owns the cabinet drawing review the overlay.
What should purchasing put in the RFQ?
“Please review AFL Motor B3P190-EC072-061 for our compact AHU. Our required airflow is ___ m³/h at ___ Pa with a clean filter and ___ m³/h at ___ Pa at the filter change point. The available supply is ___ and our controller uses ___. Please return the marked model curve, the dimensioned outline and the wiring diagram for this suffix. Flag any point or interface that needs a different model.”
Attach the cabinet section to that request. When the reply arrives, record which duty points the supplier confirmed and which drawing revision engineering checked. Those two records give purchasing a clear basis for releasing the sample order.
Buyer FAQ
Does a 190 mm impeller establish whether the fan fits my AHU?
No. Impeller diameter does not establish the complete assembly envelope. Compare the drawing for the complete B3P190-EC072-061 code with the available depth, mounting points, cable clearance and service access. Submit the equipment layout and drawing revision when requesting a fit review.
Can I use the listed 95 W to calculate power at my operating point?
The listed input is a catalogue reference, not a power value established for every combination of airflow, pressure and speed. Request the curve and power data for the complete model at your proposed operating point. Compare candidates at the same airflow, pressure definition, supply and control condition before estimating operating energy.
How should clean and loaded filter conditions be reviewed?
Provide a separate airflow and pressure requirement for each filter condition, with units and a clear statement of which system restrictions are included. Ask which speed and control setting would be proposed for each point. A variable-speed reference alone does not establish that your controller will maintain airflow; record any unverified point before approving a sample.
Which documents should accompany a sample review?
Request the current performance curve, outline drawing and wiring information for the complete model code. Identify supply voltage and frequency, control interface, installation clearance and the document revisions used in the review. Keep the sample label and test configuration with the results so that a later quotation can be checked against the same configuration.